( 2 ) Inswool Pumpable 10 oz. caulk, Ceramic Refractory in tube, repair / seal

Description

INSWOOL PUMPABLE is a 2300°F ceramic fiber, putty-like consistency material, especially formulated for pumping with special equipment. It is usually used for pumping behind existing hot face linings for insulating purposes; however it can be used to fill small voids and thin cracks. ............................................................................................................................................................................................. INSWOOL PUMPABLE is a light weight material with very low thermal conductivity, and therefore a good insulator. It dries to a firm, board-like consistency, for good sturdy integrity. Its ability to compress makes it ideal for expansion joints, and for filling contraction cracks. In addition it is used in contact with molten aluminum. ................................................................................................................................................................................................... Although normally used as a backup material for hot spots, as mentioned above, when used as a hot face material, the INSWOOL PUMPABLE has excellent thermal shock resistance, and can be dried or put into service immediately with no pre-heat required, with the exception of direct molten metal contact. Then the INSWOOL PUMPABLE should first be thoroughly dried, and fired, to remove all mechanical water the entire depth of the material, to avoid dangerous steam explosion. ......................................................................................................................................................................................................... Warning:...................................... This is a refractory material which is hazardous to your health if ingested or inhaled. Wear gloves and mask when handling. MSDS is available on request............... ................................................................................................................... Testing Policy: Testing of raw materials should be an integral part of any process including ceramic or glass making / manufacturing. Upon receipt of any new material, we strongly recommend that you test the material. "Paul Brown Studio Arts and Supplies" . has no control over either the variations that may occur in the natural materials or their application. All products are supplied as is from the manufacturer. No additional processing or technical support is supplied. Therefore, our products are sold with the understanding that the user is solely responsible for determining suitability for any purpose and the results obtained. There are no warranties expressed or implied, regarding the user’s finished product or results. ............................................................................................................................................................................................................................................................................................................................. Return Policy: Returns are NOT accepted
Here for you consideration is a Riverview #422 Ceramic Mold in  good condition. It will produce two Christmas Ornaments about 2.25"-3" Tall x 1.5"-2.5" wide in diameter in greenware. The overall dimensions of the mold are 6.25" x 5" x 2".
These molds appear to be in good condition, but please examine photos carefully and ask any questions before bidding. As you may know, many of these mold companies have gone out of business so availability is limited.
Please check out my other listings and those of my partner wdj2d, we have many other molds listed.
This mold was an estate find so I cannot really vouch for its former environment although I believe it had been in storage a couple of years.
Thanks for looking and Good Luck!
Shipping to USA addresses only.
Shipping, Handling and Insurance is all included in the price.