Inswool Pumpable 10 oz. caulk, ( 5 ) Ceramic Refractory tubes, repair / seal

Description

This is a bulk price for 5 TUBES of Inswool Pumpable Caulk, uses a standard caulking gun INSWOOL PUMPABLE is a 2300°F ceramic fiber, putty-like consistency material, especially formulated for pumping with special equipment. It is usually used for pumping behind existing hot face linings for insulating purposes; however it can be used to fill small voids and thin cracks. ............................................................................................................................................................................................. INSWOOL PUMPABLE is a light weight material with very low thermal conductivity, and therefore a good insulator. It dries to a firm, board-like consistency, for good sturdy integrity. Its ability to compress makes it ideal for expansion joints, and for filling contraction cracks. In addition it is used in contact with molten aluminum. ................................................................................................................................................................................................... Although normally used as a backup material for hot spots, as mentioned above, when used as a hot face material, the INSWOOL PUMPABLE has excellent thermal shock resistance, and can be dried or put into service immediately with no pre-heat required, with the exception of direct molten metal contact. Then the INSWOOL PUMPABLE should first be thoroughly dried, and fired, to remove all mechanical water the entire depth of the material, to avoid dangerous steam explosion. ......................................................................................................................................................................................................... Warning:...................................... This is a refractory material which is hazardous to your health if ingested or inhaled. Wear gloves and mask when handling. MSDS is available on request...............
Testing Policy: Testing of raw materials should be an integral part of any process including ceramic or glass making / manufacturing. Upon receipt of any new material, we strongly recommend that you test the material. "Paul Brown Studio Arts and Supplies" . has no control over either the variations that may occur in the natural materials or their application. All products are supplied as is from the manufacturer. No additional processing or technical support is supplied. Therefore, our products are sold with the understanding that the user is solely responsible for determining suitability for any purpose and the results obtained. There are no warranties expressed or implied, regarding the user’s finished product or results.
Return Policy:  NO RETURNS on this item
TF-3 Paragon Replacement Control Relay for most Paragon 220/240 Volt Kilns
TF-3 Paragon Control Relay
Relay 30 AMP, 12 Volt Coil
This relay fits Kilns that run on 220V/240 volts. This is the relay for the 18" and up kilns. There are usually 2 or more of these relays in the larger kilns. These relays cycle and off during the firing. Relays have a life in the 300,000 click range. If one bank of coils does not heat or stays on, then a new relay is needed. If a relay fails on, switch the kiln off at the breaker and unplug the kiln. Do not run the kiln again until the relay has been changed. It takes all the relays working together for the kiln to work properly.
Check your kiln to make sure of fitment.
You may have more than one installed.